Filter
Top Products
GPSMAP 400/500 Series Owner’s Manual 53
Conguring the Chartplotter
2� Select the type of tank you want to label�
3� Select Choose Names�
4� Select a tank�
3� Select the location of the tank: Port (P), Center (C), Starboard
(S), Fore (F), or Aft (A)�
4� Select the label you want to use for the tank�
Setting Alarms
You can set the unit to sound an audible alarm when certain
conditions are met. By default, all alarms are turned off.
To set an alarm:
1� From the Home screen, select Congure > Alarms�
2� Select an alarm category�
3� Select an alarm�
4� Select On to turn on the alarm�
5� Specify alarm information�
Setting Navigation Alarms
To set a navigation alarm from the Home screen, select
Congure > Alarms > Navigation�
—set an alarm to sound when you are within a specied
distance or time from a turn or a destination waypoint.
• —select whether you want arrival alarms to sound only
when nearing destinations or when nearing either turns or
destinations. Select to disable arrival alarms.
• —select whether the arrival alarm triggers on time to
arrival or distance to arrival.
• —if you have Activation set to
Time, select to set the number of minutes before
arrival that the alarm should sound. If you have Activation set
to Distance, select to set the distance before
arrival that the alarm should sound. Use the to change
the time or distance.
—set an alarm to sound when you exceed a specied
drift distance.
—set an alarm to sound when you are off course by a
specied distance.
Setting System Alarms
To set a system alarm from the Home screen, select Congure >
Alarms > System�
—set an alarm using the system (GPS) clock. The unit must
be on for the clock alarm to work.