Filter
Top Products
5. VIDEO PLOTTER OPERATION
5-38
[CARD (1/2)]
1 BACK
2 DRIVE SELECT
A/B/C/D*
3 [READ CARD]
4 [WR MARK]
5 [WR NAV LINE•WPT]
6 [WR OWN TRACK]
7 [WR TARGET TRACK]**
8 [WR SETTING DATA]
9 [WR INSTALL DATA]
0 NEXT
5.15 Replaying Data
Video plotter data (track, marks, etc.) may be replayed on the screen. This is
useful for analyzing past data.
1. Insert memory card into the appropriate slot in an I/F card unit.
2. Roll the trackball to choose the MENU box and then push the left button.
3. Roll the wheel to choose 6 [CARD] and then push the wheel or the left
button.
CARD menu
4. Roll the wheel to choose 2 DRIVE SELECT and then push the wheel or the
left button.
5. Roll the wheel to choose the drive where you inserted the memory card.
6. Push the wheel or the left button.
7. Roll the wheel to choose 3 READ CARD and push the wheel or the left
button.
READ CARD menu
8. Roll the wheel to choose the data to replay.
9. Push the wheel or the left button to replay chosen data.
The message “RD CARD DATA” is shown during playback. If you chose WR
INSTALL DATA, the prompt “POWER ON RESET” appears; turn the power off
and on again to read in installation data.
[READ CARD (1/1)]
1 BACK
2 NAME
T200304109
.
.
.
9 NAME
R200307318
0 NEXT
* Drives available are shown.
** Not available on IMO type