Filter
Top Products
5. VIDEO PLOTTER OPERATION
5-31
[NAV LINE•WPT (1/2)]
1 BACK
2 NAV LINE DATA
OFF/EXT DATA/
INTERNAL DATA/
WPT MARK*
3 NAV LINE SELECT
00
FORWARD/REVERSE
4 SKIP NEXT WPT
5 NAV LINE WIDTH
0.00NM
6 [WPT SET]
7 [WPT LIST]
8 [NAV LINE SET]
9 [NAV LINE LIST]
0 NEXT
Erasing all nav lines
1. Roll the trackball to choose the MENU box and then push the left button.
2. Roll the wheel to choose 5 PLOTTER and then push the wheel.
3. Roll the wheel to choose 8 [DATA ERASE] and then push the wheel.
[DATA ERASE]
1 BACK
2 OWN TRACK
RED/GRN//BLU/YEL/
CYA/MAG/WHT/
30%/50%/80%/ALL
3 TARGET TRACK*
RED/GRN//BLU/YEL/
CYA/MAG/WHT/
30%/50%/80%/ALL
4 MARK ALL ERASE
NO/YES
5 WPT ALL ERASE
NO/YES
6 NAV LINE ALL ERASE
* Not
available
on
IMO
type
DATA ERASE menu
4. Roll the wheel to choose 6 NAV LINE ALL ERASE.
5. Roll the wheel to choose YES and then push the wheel or the left button to
erase all nav lines and their data.
6. Push the right button three times to close the menu.
5.13.5 Setting up nav lines
Nav lines can be set up as follows:
1. Roll the trackball to choose the MENU box and
then push the left button.
2. Roll the wheel to choose 8 [NAV LINE•WPT]
and then push the wheel or the left button.
3. Roll the wheel to choose 2 NAV LINE DATA
and then push the wheel or the left button.
4. Roll the wheel to choose INTERNAL DATA and
then push the wheel or the left button.
5. Roll the wheel to choose 5 NAV LINE WIDTH.
6. Use the wheel to enter the width for the nav
line, from 0.0-9.9(nm). A pair of red lines mark
the width of the nav line.
* Not available on IMO or A type
NAV LINE•WPT menu (1/2)