Filter
Top Products
8-3
8.5 When “BATTERY ALARM!”
Appears
A lithium battery (type: TZ6580553A, code
no.: 000-139-051) is installed on the circuit
board inside the display unit and it preserves
data when the power is turned off. The life
of the battery is about three years. When the
battery voltage is low “BATTERY
ALARM!” appears on the display to alert
you. When this happens, contact your dealer
to request replacement of the battery.
8.6 Clearing Data
You may clear GPS data and menu settings
individually or collectively, to start afresh
with default settings or, in some cases, re-
store normal operation. If you require pre-
vious menu settings jot them down before
clearing data. To fix position again, when
GPS data is cleared, reset the power.
GPS data
1. Press the [MENU] key twice.
2. Select ERASE and press the [ENT] key.
3. Select GPS DATA? and press the [ENT]
key. The following message appears.
ARE YOU SURE?
YES NO
ERASE GPS DATA?
Figure 8-6 Prompt for erasure
of GPS data
4. Press the [ENT] key.
RESTART FOR
ERASING DATA.
HIT ANY KEY.
Figure 8-7 Prompt for restarting
5. Press any key. The buzzer sounds while
GPS data is being cleared.
Clearing menu settings
All default menu settings are restored when
menu settings are cleared. Note that
waypoints and routes are not cleared.
1. Press the [MENU] key twice.
2. Select ERASE and press the [ENT] key.
3. Select MENU SETTINGS? and press the
[ENT] key. The following message ap-
pears.
ARE YOU SURE?
YES NO
MENU SETTINGS
TO DEFAULT?
Figure 8-8 Prompt for erasure
of menu settings
4. Press the [ENT] key.
RESTART FOR
ERASING DATA.
HIT ANY KEY.
Figure 8-9 Prompt for restarting
5. Press any key. The buzzer sounds while
menu settings are being cleared.