Filter
Top Products
2-3
4. The cursor should be on the TRACK
REC line. Press the [ENT] key. The track
recording method selection window ap-
pears.
OFF
DISTANCE
AUTO
Figure 2-7 Track recording
method selection window
5. Select OFF, DISTANCE or AUTO and
then press the [ENT] key.
OFF: Track is neither recorded or plot-
ted. This setting is useful when you do
not need to record track, for example,
when returning to port.
DISTANCE: Track is recorded and plot-
ted at the distance interval set.
AUTO: Plotting and recording interval
changes with chart scale selected.
If you selected DISTANCE, enter the re-
cording interval as follows:
a) Press the [ENT] key.
b) Press t or s to select digit to change.
c) Press ▲ or ▼ to change value.
d) Press the [ENT] key after setting.
6. Press the [MENU] key twice to finish.
2.6 Erasing Track
All track can be erased. Track cannot be re-
stored once erased. Be absolutely sure you
want to erase all track.
1. Press the [MENU] key twice.
2. Select ERASE and press the [ENT] key.
The ERASE menu appears.
WAYPOINTS/MARKS?
ROUTES?
TRACK?
GPS DATA?
MENU SETTINGS?
ALL BACKUP DATA?
ERASE
Figure 2-8 ERASE menu
3. Select TRACK? and press the [ENT] key.
The message shown in Figure 2-9 ap-
pears.
ERASE TRACK.
ARE YOU SURE?
YES NO
Figure 2-9 Prompt for erasure of track
4. Press the [ENT] key to erase all track.
5. Press the [MENU] key twice to finish.