Filter
Top Products
7. NAVIGATION
7-5
Navigating to ports, port service
Some NavChart™ and C-MAP NT chart cards have a port service list which
shows services available at ports or harbors. You can use the list to set
destination as follows.
1. Referring to page 7-1 for the procedure, set SET TO GOTO METHOD to “3.
NEAR SERVICE” or “4. PORT SERVICE” (NavChart
TM
only)
NEAR SERVICE displays the port service list.
PORT SERVICE shows a list of ports in your area.
2. Press the [DISP] key, and then select PLOTTER NAV INFO 1 or PILOT NAV
INFO 1 display.
3. Press the [DISP] key. If the cursor disappears, press the [CURSOR ON/OFF]
key.
4. Press the [GOTO] key.
A list of ports or port services appear depending on what you selected at step 1.
▼
PORT SERVICE
Near service list (NavChart )
▼
TM
PORT SERVICE
ACCIAROLI
ACQUAMORTA
AGNONE S. NICOLA
AGROPOLI
AMALFI
BAIA
CAPRI
CASA MICCIOLA-ISCHIA
▲
Port service list
(NavChart , Italy)
TM
+
+
RT
Near service list
(C-MAP NT)
Port service lists
5. Do one of the following depending on selection mode at step 1.
PORT SERVICE (NavChart
TM
/FURUNO only)
Rotate the [ENTER] knob to select port and then press the [ENTER] knob. Make
a route using the trackball and [ENTER] key. (If you want to go directly to that
port, simply press the [ENTER] knob twice.