Furuno GP-3500 GPS Receiver User Manual


 
1. BASIC OPERATION
1-18
Entering character
SELECT ALPHANUMERIC CHARACTER BY TRACKBALL AND PRESS KNOB
TO ENTER. OR PRESS NUMERIC KEY TO NAME WAYPOINT.
MOVE THE CURSOR TO "END" ONCE THE EDITION IS FINISHED.
END
ABCDE FGHIJ KLMNO PQRST UVWXY
Z,-!? /&^=# 12345 67890 _____
abcde fghij klmno pqrst uvwxy
z____ _____ _____ ______ _ __
PASSWORD ENT AGAIN
Digit cursor Cursor
Ex. Set password, entering characters
1. Roll the trackball in up-down direction to select the first alphanumeric
character with the cursor (red square).
Numeric may also be entered by pressing numeric key.
2. Press the [ENTER] knob.
Note: If you make a characteristic mistake, move the cursor to the error position
and then re-enter the proper character. To move the digit cursor, select
and then press the [ENTER] knob for left direction, or select and then
press the [ENTER] knob for right direction.
Press the [CLEAR] key to erase the all characters.
3. Repeat steps 1 and 2 to complete the naming.
4. Finally, select "END" and then press the [ENTER] knob.