Filter
Top Products
E-SERIES
(May, 2004)
7
VEHICLE DESCRIPTION
VEHICLE DESCRIPTION
INCOMPLETE VEHICLE MANUAL COVER
The cover of this manual identifies the three incomplete
vehicle con gurations for which compliance representations
are contained in this manual. Also, a label is af xed to the
cover which includes the Vehicle Identi cation Number (VIN)
for the speci c vehicle to which this manual belongs. The label
identi es the following information which pertains only to the
vehicle with the corresponding VIN.
•
The GVWR
•
The front and rear GAWRs
•
Tire and wheel size
•
Cold tire in ation pressure (kPa/PSI)
•
Completed vehicle type(s) into which the incomplete
vehicle may be manufactured
•
Optional prep package when the vehicle is so equipped
INCOMPLETE VEHICLE LABEL
All E-Series incomplete vehicles manufactured by Ford Motor
Company will have an incomplete vehicle label af xed to the
driver-door lock pillar, except Basic (Stripped) Chassis. The
incomplete vehicle label for the Basic (Stripped) Chassis is
af xed to the front structure. The sample labels, shown below,
are typical of that provided.
The 5th, 6th, and 7th digits of the Vehicle Identification
Number (VIN) will identify the incomplete vehicle type. These
three digits are used in the Completed Vehicle Types charts
on page 8.
California Air Resources Board (CARB), requires a Vehicle
Identi cation Number (VIN) Label having a non-contact, bar-
code, reading wand capability. The bar-code directly below
the VIN on the incomplete vehicle label, when provided, will
comply with this regulation. See page 51 for location and other
requirements.
The Canadian Motor Vehicle Safety Act and Regulations
require installation of an incomplete vehicle certi cation label
with the National Safety mark on it on vehicles manufactured
for sale in Canada. A label representative of those installed by
Ford Motor Company assembly plants is shown below.
OPTIONAL PREP PACKAGES
Incomplete vehicles produced by Ford Motor Company,
in some instances, are equipped with an optional prep
package. These include the Ambulance Prep, School Bus
Prep, Motorhome Prep, and Shuttle Bus Prep. The completed
vehicle type charts on page 8 will identify incomplete vehicles
and the optional prep packages or trim codes that may be
required by Ford Motor Company if nal stage manufacturers
wish to rely on the Statements of Conformity or, in some cases,
preserve the Ford Motor Company new vehicle warranty.
If an incomplete vehicle is equipped with an optional prep
package, both the incomplete vehicle label affixed to the
vehicle and the label on the front of this manual will identify
the prep package.
INCOMPLETE VEHICLE LABELS
INCOMPLETE VEHICLE MANUFACTURED BY
FORD MOTOR COMPANY
MADE IN U.S.A.
GVWR:
:
FRONT GAWR
:
VIN
:
PSI COLD
PSI COLD
WITH
TIRES
RIMS
WITH
TIRES
RIMS
REAR GAWR
:
EXTERIOR PAINT COLORS
WB
TYPEGVW
BODY
TRANS
AXLE
TAPE
SPRINGS
161
F379
AJ8
E 6
5
N Y
4200LB
1905KG
LT215/85R16D
16X6K
11000LB/4989KG
8250LB
3742KG
LT215/85R16D
16X6K
65
DUAL
58
F85B1520472AB
TYPICAL E-SERIES - U.S.
AT
AT
TYPICAL E-SERIES - CANADA
VSO
410047
BAR CODE V.I.N
(CALIFORNIA
)
VSO
VEHICLE
DATE OF
MANUFACTURE
VEHICLE TYPE
(SEE CHART
ON PAGE 8)
OPTIONAL
PREP PACKAGE
VSO
VEHICLE
DATE OF
MANUFACTURE
VEHICLE TYPE
(SEE CHART
ON PAGE 8)
01/05
DATE
01/05
DATE
1FDKE37HZ5HA24638
EQUIPPED WITH THE FORD
AMBULANCE PREP PKG.
VSO
1019
.
1FDKE37HZ5HA24639