Filter
Top Products
E-SERIES (May, 2004)24
E-SERIES (May, 2004) 25
205 The statement below is applicable to all incomplete
vehicle types, except the Basic (Stripped) Chassis:
This vehicle, when completed, will conform to
Standard 205, Glazing Materials, if no alterations to
or replacements of the installed glazing materials are
made and if additional glazing materials installed by
a subsequent stage manufacturer conforms to the
requirements of Standard 205.
205 The statement below is applicable to the following
incomplete vehicle type:
• E-Series Basic (Stripped) Chassis
Conformity with Standard 205, Glazing Materials, is not
substantially affected by the design of this incomplete
vehicle: accordingly, Ford Motor Company makes no
representation as to conformity with this Standard.
206 The statements below are applicable to all incomplete
vehicle types except the Basic (Stripped) Chassis,
when completed as a Truck:
This vehicle, when completed, will conform to Standard
206, Door Locks and Door Retention Components, if
no alterations or adjustments are made to the door,
door pillar structure, door locks, door latches, striker
plates, hinges, and attaching hardware as installed by
Ford Motor Company.
Any door added to this vehicle by a subsequent stage
manufacturer must be equipped with door locks and
door retention components that conform with this
Standard.
206 The statement below is applicable to the following
incomplete vehicle type, when completed as a Truck:
• E-Series Basic (Stripped) Chassis
Conformity with Standard 206, Door Locks and Door
Retention Components, is not substantially affected
by the design of this incomplete vehicle; accordingly,
Ford Motor Company makes no representation as to
conformity with this Standard.
207, 208, 209, and 210 INFORMATION
For additional information to assist in designing seats,
seat belt systems, and seat belt anchorages that comply
with Standard 207, 208, 209, and 210 applicable to
Incomplete E-Series Van and Cutaway vehicles with no
front seats provided by Ford Motor Company, refer to the
Design Recommendation section of the Ford Truck Body
Builders Layout Book for Seat and Lap & Shoulder Belt
System information that is in addition to the statements
which follow.
207 The statements below are applicable to the following
incomplete vehicle types when equipped with trimmed
front seats:
• Incomplete E-Series Van or Wagon
• Cutaway
This vehicle, when completed, will conform to Standard
207, Seating Systems, if no alterations are made to the
seat assemblies, their anchorages, the oor pan, or
oor pan reinforcements. Any seating system added to
this vehicle must conform to applicable requirements
of this Standard. When the Cutaway is completed as a
school bus, see Standard 222 also.
If the front seat attaching hardware is removed for any
reason, it must be reinstalled to the specications in
Figure B for E-Series on page 31.
The Incomplete E-Series Recreational Van or the
Incomplete E-Series Wagon may have additional
anchorages for rear seats other than the front driver
and passenger seats. These locations apply to specic
hardware and designated seating positions used in
Ford completed vehicles. If these anchorages are
used without the appropriate Ford seats, seat belt
systems, and hardware, Ford Motor Company makes no
representation as to conformity with this Standard.
207 (Continued Next Page)
STATEMENTS OF CONFORMITY