Filter
Top Products
E-SERIES (May, 2004)8
E-SERIES (May, 2004) 9
STATEMENTS OF CONFORMITY
STATEMENTS OF CONFORMITY
The following Statements of Conformity apply to vehicles that are produced for sale or importation into the United States
or Canada. The term “Incomplete Vehicle Types” in these statements refers to the three types of the vehicles illustrated on
this manual’s cover and listed in the chart on page 8.
The number preceding each Statement of Conformity refers to the number designation for a Part or a Section of Part 571
of the Federal Motor Vehicle Safety Standard.
The statements provided for each safety standard number are appropriate compliance representations for each Canadian safety
standard number if this incomplete vehicle, identied by the VIN on the front of the document, was manufactured by Ford Motor
Company for sale or use in Canada, except as may be noted at the conclusion of each safety standard number.
PART
565.4 The statement below is applicable to all incomplete
vehicle types except the Basic (Stripped) Chassis:
This vehicle, when completed, will conform to Part 565.4,
Vehicle Identication Number, if the vehicle identication
number mounted on the top of the instrument panel is
not removed, altered, or modied and no actions are
taken by the subsequent stage manufacturer that would
obstruct the readability of the Vehicle Identification
Number mounted on the top of the instrument panel.
565.4 The statements below are applicable to the following
incomplete vehicle type:
• E-Series Basic (Stripped) Chassis
This vehicle, when completed, will conform to Part
565.4, Vehicle Identication Number, if:
• The E-Series vehicle identication number printed on
the label afxed to the cover of this manual is mounted
and displayed in accordance with the requirements
of this Standard.
101 The statements below are applicable to the following
incomplete vehicle types when equipped with a
driver seat:
• Incomplete E-Series Van or Wagon
• Cutaway
This vehicle, when completed, will conform to Standard
101, Controls and Displays if:
• The controls, displays, and their identifications
supplied by Ford Motor Company are not removed,
relocated, altered, or modied.
• The components, wiring, and power supply installed
by Ford Motor Company to illuminate any control,
display, or their identification are not removed or
altered so as to affect lighting performance.
• Components added to the vehicle do not obstruct
the driver’s ability to operate or visually locate the
controls, displays, and their identications.
• The driver-seat is not replaced, relocated, or modied
other than for the addition of seat trim.
Any controls, displays, and illumination added to this
vehicle must conform to the requirements of this
Standard.
101 The statements below are applicable to the following
incomplete vehicle types with no driver-seat:
• Incomplete E-Series Van
• Cutaway
This vehicle, when completed will conform to Standard
101, Controls and Displays if:
• The Seating Reference Point (see denition on page
5) and the seat back torso angle of the driver-seat
when completed or installed by a subsequent stage
manufacturer are located as shown in the Figure C
page 32, for E-Series type vehicles.
• The controls, displays, and their identifications
supplied by Ford Motor Company are not removed,
altered, or relocated.
• The components, wiring, or power supply installed by
Ford Motor Company to illuminate any control, display,
or their identication are not removed or altered so
as to affect lighting performance.
• Components added to the vehicle do not obstruct
the driver’s ability to operate or visually locate the
controls, displays, and their identications.
Any controls, displays, and illumination added to
this vehicle must conform to the requirements of this
Standard.
101 The statement below is applicable to the following
incomplete vehicle type:
• E-Series Basic (Stripped) Chassis
Conformity with Standard 101, Controls and Displays, is
not substantially affected by the design of this incomplete
vehicle; accordingly, Ford Motor Company makes no
representation as to conformity with this Standard.