Filter
Top Products
E-SERIES (May, 2004)42
E-SERIES (May, 2004) 43
STATEMENTS OF CONFORMITY
301 (Continued)
301 (Continued Next Page)
† Temporary removal of the front bumper and front bumper mounting
system during manufacture and reinstallation in accordance with
the instructions provided in the Ford Truck Shop Manual should not
adversely affect compliance of the completed vehicle to Standard
301.
OUTBOARD
FRAME REINFORCEMENT
BACK-TO-BAC
K
CROSSMEMBER
S
LOWER FRAME
FLANGE REINFORCEMENT
S
OUTBOARD
FRAME REINFORCEMENT
FIGURE H – E-SERIES CUTAWAY WITH GASOLINE ENGINE AND SCHOOL BUS PREPARATION PACKAGE
• No other alteration or modification made to the
incomplete vehicle, as manufactured by Ford Motor
Company, and no other components or structure
installed by a subsequent stage manufacturer result
in penetration, separation, or other damage to the
fuel system or any portion thereof when the vehicle is
tested in any manner specied by applicable provisions
of Standard 301.†
• The completed vehicle’s Unloaded Vehicle Weight
does not exceed the value designated in Table A for
E-Series on page 15 corresponding to the incomplete
vehicle’s model and wheelbase.
301 The statements below are applicable to the following
incomplete vehicle types if the vehicle GVWR is
4536 kg [10,000 lb] or less:
• Cutaway
• E-Series Cutaway (SRW) with Diesel Engine
and School Bus Preparation Package
• E-Series Cutaway (SRW) with Gasoline Engine
and School Bus Preparation Package
This vehicle, when completed, will conform to Standard
301, Fuel System Integrity, if:
• The following fuel system components as installed
by Ford Motor Company are not removed, relocated,
altered, or modied in any way except as specied in
the following representations:
– Fuel tank(s) and attachment hardware, including
sending unit, vapor valve, fuel tank shield, pressure
transducer, and in-tank electric fuel pump
– Fuel ller cap(s), pipe(s), hose(s), and attachment
hardware
– Fuel lines, routing, and attachments
– Vapor line(s) and carbon canister – (gasoline engine
application)
– Fuel pump
– Fuel lter
– Fuel water separator fuel filter/primer, fuel line
heater, and injection pump – (diesel engine only)
– Fuel shut off switch (Inertia switch)
– The two Outboard Frame Reinforcements, two
Lower Frame Flange Reinforcements, and two
extra back-to-back crossmembers, all shown above,
and all unique to the gasoline engine School Bus
Package.
• No other alteration or modification made to the
incomplete vehicle as manufactured by Ford Motor
Company and no other components or structure
installed by a subsequent stage manufacturer result
in penetration, separation, or other damage to the
fuel system or any portion thereof when the vehicle
is tested in any manner specified by applicable
provisions of Standard 301.†
• The completed vehicle’s Unloaded Vehicle Weight
does not exceed the value designated in Table A on
page 15 corresponding to the model and wheelbase.