Filter
Top Products
E-SERIES (May, 2004)32
E-SERIES (May, 2004) 33
STATEMENTS OF CONFORMITY
FIGURE D – E-SERIES OCCUPANT PROTECTION ZONE
SRP INFORMATION POINT A
(SEAT POSITION IS 10.0mm [0.39 IN] FORWARD (SEAT POSITION IS AT THE MIDPOINT
OF REARMOST POSITION) OF AVAILABLE TRAVEL)
A B C D E F
MIN. MAX.
DRIVER – SEAT (VAN AND CUTAWAY) 217.8 105.0 384.2 356.0 67.0 937.4
[8.57] [4.13] [15.13] [14.01] [2.64] [36.90]
PASSENGER – SEAT (VAN AND CUTAWAY) 277.3 103.0 377.0 412.0 65.0 960.1
[10.92] [4.06] [14.84] [16.22] [2.56] [37.80]
IMPORTANT:
THE TORSO ANGLE IS DETERMINED BY
USING THE METHOD SPECIFIED IN
SAE J826 (MAY 1987)
POINT
A
D
A
F
C
[ ] DIMENSIONS ARE INCHES
E
E
POINT A
POINT A
DRIVER SEAT
PASSENGER SEAT
C
L
VEHICLE
B
B
DRIVER SIDE ONLY
TORSO ANGLE
18 DRIVER
21 PASSENGE
R
SEAT
BASE
SEAT
BASE
C
L OUTSIDE
FRONT
FASTENER
C
L OUTSIDE
FRONT
FASTENER
THE DIMENSIONS IN THIS FIGURE REQUIRE THE VEHICLE TO BE AT
DESIGN POSITION. ECONOLINE VAN VEHICLES AT DESIGN POSITION
WILL BE LEVEL FRONT TO REAR, AND SIDE TO SIDE, ON THE UPPER
SURFACE OF THE RIBBED FLOOR PANEL FROM THE B-PILLAR REARWARD.
C
L OUTSIDE
FRONT
FASTENER
SEAT BACK
PIVOT
6.
0
[0.24]
510.
0
[20.08
]
HEEL
POINT
SRP HAS A 12.7 [0.50] RADIAL
TOLERANCE PERMITTED FROM
BASE SRP
FIGURE C – E-SERIES SEATING REFERENCE POINT (SRP)
DO NOT INSTALL ADDITIONAL COMPONENTS IN THE
SHADED AREAS, OR ALTER OR MODIFY THESE AREAS.