Filter
Top Products
7
Introduction
Operating safety
Body builders and dealers who make any
modifications which may affect the final
certification of the engine, vehicle or
equipment assume the sole responsibility
for the vehicle, including labeling and doc-
umentation, affected by their modifica-
tions.
It is their responsibility to certify that the
altered vehicle conforms to all applicable
standards and regulations affected by the
vehicle alteration or continues to comply
with the motor vehicle safety standards
and emissions regulations.
They are responsible for ensuring that
modifications or equipment installation
does not affect the safety of the vehicle.
The manufacturer is not responsible for
any final certification or claims regarding
product liability, or warranty claims, which
result from any component, assembly, or
system being altered, or which cause non-
compliance with any of the emission con-
trol standards or motor vehicle safety stan-
dards, or which would otherwise cause the
vehicle to be or become defective or un-
safe.
The manufacturer does not assume the re-
sponsibility as the final stage manufacturer
or the consequential product liability.
Observe the following information when
using your vehicle:
ț The safety notes in this manual
ț The “Technical data” section in this
manual
ț Traffic rules and regulations
ț Motor vehicle laws and safety stan-
dards
Warning G
Any modifications or alterations of the
Sprinter vehicle not in compliance with the
Sprinter Body Builder Guideline and the
Sprinter Operator’s Manual may seriously
inhibit its roadworthiness and safety and
may lead to an accident resulting in serious
personal injury or death.
Consult the Sprinter Body Builder Guideline
and the Sprinter Operator’s Manual prior to
initiating any alterations or modifications.
Correct use
Warning G
Be sure to read the Operating Instructions.
Otherwise, you may not be aware of certain
risks and could injure yourself or others.