Filter
Top Products
301
Practical hints
Where will I find...?
5
3 Tensioning lever
4 Jack
5 Vehicle tool kit
̈ Remove the vehicle tool kit.
̈ Pull tensioning lever 3 upward and
unhook the retaining strap of jack 4.
̈ Remove jack 4 upward out of the re-
tainer.
If you are replacing the tires on the vehicle,
you may use the spare wheel as a road
wheel provided that:
ț the tires are no more than 6 years old
ț the wheel and tire have the same spec-
ified design as the road wheels
The spare wheel is located in a spare wheel
bracket under the rear of the vehicle.
More information about tire inflation pres-
sures can be found in the "Operation" sec-
tion (୴ page 213).
Panel van/crewbus
1 Cover
2 Recess
̈ Open the rear doors (୴ page 61).
̈ Insert a screwdriver into recesses 2
and pry off covers 1.
̈ Using the wheel wrench from the vehi-
cle tool kit (୴ page 300), now unscrew
the visible bolts approximately
20 turns counterclockwise.
i
Place the jack into the retainer as
shown when storing it back into place.
Make sure that the jack’s retaining
strap is hooked in and tensioned.
Spare wheel
!CAUTION
Check regularly that the spare wheel is
secured correctly.