Filter
Top Products
322
Practical hints
Flat tire
5
Hydraulic jack
̈ Assemble the three-part pump lever for
the jack.
1 Pressure release screw
̈ Close pressure release screw 1.
̈ To do this, turn the flattened section on
the pump lever clockwise to the stop.
̈ Insert the pump lever into the recess
on the jack and secure it by turning it
clockwise.
̈ Make sure that the jack is positioned
vertically under the jacking points de-
scribed below.
̈ Raise the vehicle by pumping the lever
until the wheel is raised clear of the
ground.
Make sure that the distance between
the underside of the tires and the
ground does not exceed 1.2 in (3 cm).
Jacking point at the front axle
The vehicle jacking point is located under
the longitudinal member in front of the
front axle.
Jacking points at the rear axle
The vehicle jacking point is located under
the longitudinal member in front of the rear
axle.
Vehicle model type 2500
Vehicle model type 3500
i
Never turn pressure release screw 1
more than 1 or 2 full turns. Hydraulic
fluid could otherwise escape.
P58.10-2053-31
N40.10-2260-31
N40.10-2161-31