Filter
Top Products
Apollo CNX80 Pilot’s Guide
3
MENU/ENTER and Line Selection Keys
When editing information, or a response is required, pressing this key
accepts the value. In other cases, pressing this key will bring up a
series of menu items on the right side of the display. The menu items
are then selected by pressing the key to the right of it. Pressing the
Menu/Enter key while the menu items are shown will make them dis-
appear.
Large/Small Knobs
You can move the cursor or highlight information by turning the Large
knob. Turn the Small knob to change information.
CRSR
Press the Small knob in to activate the cursor. The area on the display
that you can now edit will be highlighted. Now you can change informa-
tion with the Small knob and move the cursor to the next area to edit
with the Large knob. If you are in Map mode, pressing the CRSR acti-
vates PAN mode. In Transponder mode, it allows editing codes.
FN
Press the FN key to page through the available gro of Functions that
appear at the bottom display. The “smart” keys located below each
label will activate that function.
Datacard
The Map database and other information is stored on a data card. The
use of a data card allows you to easily update information.
Note
Only change the data card when the power is turned
off or you may damage your unit.
Handle your data card carefully. Do not touch the connector edge of
the data card. To eject the card, press the data card ejector. Gently pull
the card straight out of the slot. Insert a data card by pushing the card
straight into the slot. When fully inserted, the data card and eject but-
ton will be flush and slightly recessed into the bezel.
When contacting your dealer or the Garmin AT technical services staff,
eject the data card and write down the information shown on the label.
Note
Never insert or eject the data card with the power on.
Controls
CNX80 Pilot Guide 560-0984-00C Draft1.book Page 3 Tuesday, September 2, 2003 10:36 AM