Filter
Top Products
Apollo CNX80 Pilot’s Guide
30
Steps for Setting Up an IFR Flight Plan
Procedures can be inserted at the time you are creating the flight plan
(as described here) or later with the Procedure (PROC) function.
Note
If datum for an airport is unknown, no terminal or instrument
procedures will be displayed. The Jeppesen database can
only show one procedure type per runway (i.e. ILS, GPS,
VOR). The procedures are present, but must be selected
from multiple transitions. Note that the name may not match
the paper approach. Verify the sequence of waypoints to
ensure you have selected the desired procedure.
A. Set Origin, Destination, and Alternate Waypoints.
B. Add Departure Procedure (DP).
C. Insert en route flight plan of Airways and/or Waypoints.
D. Modifying a Flight Plan While in Flight
E. Add Arrival Procedures (STARS).
F. Add Approach Procedures when you receive clearance.
A. Set Origin, Destination, and Alternate Waypoints
1. In Flightplan mode, press the NEW key.
2. Use the Large and Small knobs to select the Origin waypoint. Press
Menu/Enter.
3. The Destination waypoint selection page will now be displayed.
Select the Destination waypoint and press Menu/Enter.
4. Set an Alternate airport, if desired. Turn the Large knob CCW to
highlight the flight plan name. Press the Altrnt key and select an
alternate airport/waypoint along the flight plan with the Large and
Small knobs. The alternate airport will be added in parentheses to
the flight plan name.
5. Press SAVE.
Flightplan
CNX80 Pilot Guide 560-0984-00C Draft1.book Page 30 Tuesday, September 2, 2003 10:36 AM