Filter
Top Products
Apollo CNX80 Pilot’s Guide
25
VFR
Press the VFR key to select the VOR 1200 squawk code.
TrgrSpd
The TrgrSpd key allows you to edit the aircraft speed that will
switch the transponder automatically between active and standby.
See the Auto mode description below.
Auto
When Auto mode is selected, the transponder will automatically
become active after the aircraft reaches the Trigger speed. While
the aircraft is below the Trigger speed, your transponder will not
send any information.
1. In Transponder mode, press Menu/Enter.
2. If necessary, edit the Trigger Speed. Press TrgrSpd. Select the
desired Trigger Speed with the Large and Small knobs. Press
Menu/Enter.
3. Press Menu/Enter. Press the Auto key. Auto mode is active when
it is highlighted. Press Auto again when you want to deactivate
the Auto mode.
Manually Select a Squawk Code
1. Press the CRSR in or turn the Large knob to activate squawk code
editing. Numbers 0 - 7 will be displayed adjacent to the Smart and
Line Selection keys.
2. Press the key for the desired number. After pressing a numbered
key, the next number to the right will be active for editing.
OR
1. Change the number value with the Small knob and move to the next
number with the Large knob.
2. After selecting the fourth number, turning the Large knob or press-
ing Menu/Enter key will end editing.
3. You can press the CRSR knob while editing to cancel any changes.
XPDR
CNX80 Pilot Guide 560-0984-00C Draft1.book Page 25 Tuesday, September 2, 2003 10:36 AM