Filter
Top Products
Apollo CNX80 Pilot’s Guide
11
1. Press Direct-To.
2. Select a waypoint for the holding pattern.
a. Press WPTS (default) to select a waypoint along your flight plan
by turning the Large knob to highlight the waypoint. Press Hold.
or
b. Press DB to select a waypoint from the database with the Large
and Small knobs. Press Hold.
3. Use the Large and Small knobs to select Right or Left turns, hold
course, and hold length (nm or km) or hold time (minutes).
4. Press Menu/Enter. The Hold pattern will be drawn on the display
and the CNX80 will provide guidance for the holding pattern. when
you near the holding pattern flight plan sequencing is suspended.
Press SUSP (SUSP annunciator will turn off) to exit the holding pat-
tern and return to the flight plan.
Destination (Dest)
The Dest Menu selection key replaces the active flight plan with a
direct course to the displayed waypoint. You can choose a waypoint
from your flight plan (WPTS) or another waypoint from the database
(DB).
1. When you press Direct-To, the default waypoint shown will be the
highlighted waypoint in your flight plan when the WPTS smart key is
highlighted. You can turn the Large knob to select a different a dif-
ferent waypoint in your flight plan.
2. You may select a waypoint that is not in your flight plan by pressing
the DB smart key and then use the Large and Small knobs to select
the new waypoint.
3. Press the Dest key to navigate directly to the selected waypoint.
4. Press Menu/Enter to accept the new destination waypoint. Press
Menu/Enter again to activate it.
Direct-To
CNX80 Pilot Guide 560-0984-00C Draft1.book Page 11 Tuesday, September 2, 2003 10:36 AM