Filter
Top Products
80-EN
ALPINE NVD-A802 68-06194Z86-A (EN)
If this Message Appears
Various messages are displayed on the screen during operation. In addition to the messages telling you the current status or providing
guidance for the next operation, there are also the following error messages. If one of these error messages is displayed, carefully follow
the instructions in the solution column.
Cause
• The disc has been removed.
• There was no disc in the system
when the power was switched on.
•A disc that this system cannot
read has been loaded.
• The disc is dirty or upside down.
• The disc cannot be read because
of condensation.
• The MENU button was pressed
while the vehicle was running.
•A menu selection operation was
carried out while the vehicle was
running.
• The inserted DVD-ROM does not
cover the map display region or
map display region needs to be
changed to the correct region in
Setup (if map region exists in
Source Disc).
• The destination is outside the map
display region and not contained
in the inserted DVD-ROM.
• Ambient temperature over 122ºF
(50ºC)
• Application error
Message
Please insert DVD-ROM.
Error reading DVD-ROM.
Please check the disc.
If you are driving, please pull
over before using this
function.
Vehicle is out of Map display
region.
Please refer to the Owner's
Manual.
Destination is out of Map
display region.
Route cannot be calculated.
Temperature is too high.
Please allow system to cool
down.
Update failed.
Please check your disc.
Solution
Insert the disc.
Take out the disc, check if it was upside down,
clean it if necessary, then reinsert it.
Take out the disc, allow enough time for the
condensation to evaporate (about 1 hour), then
reinsert the disc.
Move the vehicle to a safe location, stop, and
engage the parking brake, then carry out this
operation.
Insert the DVD-ROM that applies to the current
map display region. If map region exists in the
Source Disc, change Map display region in Setup
to the correct region.
Insert the DVD-ROM in which the destination is
registered and contained in the map display
region.
Lower the temperature in the vehicle below
122ºF (50ºC), for example by running for a while
with the window open or by using the air
conditioner.
If the South disc is inserted, replace it with the
North disc.
The application starts updating.