Filter
Top Products
PinPoint-E EDGE/GPRS - User Guide, version 2.32 73
AT Commands: Information and Status
*POWERMODE?
&V
+CCID
+CIMI
• Network Negotiation Fail
Network connection negotiation failed. This is usually temporary and often clears up dur-
ing a subsequent attempt.
• Network Ready
The PinPoint-E is connected to the EDGE/GPRS network and ready to send data.
• Network Dormant
The PinPoint-E is connected to the EDGE/GPRS network, but the link is dormant. It will be woken
up when data is sent or received.
• No Service
There is no EDGE/GPRS network detected.
• Hardware Reset
The hardware module is being reset. This is a temporary state.
Displays the current power state/mode. Possible values returned are:
• Initial
The modem is in the initial 5 minutes since power up, so power down event will be
ignored.
• On
Regular power on, a power down is not pending.
• Low Cancellable
Power down is pending but still cancelable if the power down trigger goes away.
• Low Pending 1 and 2
Power down is pending, any modem tasks are gracefully preparing for the power down.
• Low Final
Power down is imminent.
• Low
Power is down.
View active profile (the contents of the active registers).
Not displayed with Wireless Ace.
Subscriber Identity Module ID
International Mobile Subscriber Identity