Filter
Top Products
AUTO TRANS DIAGNOSIS - 01M
Article Text (p. 38)
1996 Volkswagen Golf
For Volkswagen Technical Site
Copyright © 1998 Mitchell Repair Information Company, LLC
Thursday, August 19, 1999 11:28PM
Fig. 41: Installing Clutch Housing Circlip
Courtesy of Volkswagen United States, Inc.
4TH APPLY CLUTCH
NOTE: Soak all friction-faced clutch plates in ATF for at least 15
minutes before installation.
1) Mark circlip for installation reference and remove.
Disassemble clutch plates. See Fig. 42. Compress spring support ring,
and remove circlip. Remove spring support ring and spring. Remove
clutch piston.
2) Remove front impeller seal rings. DO NOT remove inner
impeller seal rings unless damaged. Check for worn or damaged parts
and replace as necessary.
3) Piston seal is part of piston. If damaged, replace 3rd-4th
apply clutch piston. Reassemble 3rd-4th apply clutch. See
APPLY CLUTCH PLATE APPLICATIONS table.
NOTE: Assembled clutch clearance specification is not available
from manufacturer. Ensure top thrust plate is installed with
shouldered side facing circlip.