Filter
Top Products
AUTO TRANS DIAGNOSIS - 01M
Article Text (p. 35)
1996 Volkswagen Golf
For Volkswagen Technical Site
Copyright © 1998 Mitchell Repair Information Company, LLC
Thursday, August 19, 1999 11:28PM
Fig. 37: Removing Output Gear Roller Bearing
Courtesy of Volkswagen United States, Inc.
VALVE BODY
NOTE: Disassembly and reassembly procedures are not available from
manufacturer.
1ST & 3RD APPLY CLUTCH
1) Remove support ring. Mark circlip for installation
reference, and remove circlip. Disassemble clutch plates. See Fig. 38.
Remove diaphragm spring circlip. Compress spring support, and remove
circlip. See Fig. 39. Remove spring plates and clutch piston.
2) Remove piston rings from piston. Piston seal is part of
piston. If damaged, replace 1st-3rd apply clutch piston. Remove seal
rings from turbine shaft. Check for worn or damaged parts and replace
as necessary. Ensure check ball in clutch housing is not damaged.