Filter
Top Products
AUTO TRANS DIAGNOSIS - 01M
Article Text (p. 24)
1996 Volkswagen Golf
For Volkswagen Technical Site
Copyright © 1998 Mitchell Repair Information Company, LLC
Thursday, August 19, 1999 11:28PM
Remove pressing adapter. Remove input transfer gear assembly from
transaxle case.
5) Remove speedometer drive shaft. See Fig. 23. On left axle
flange, remove bolt and remove axle flange. On right axle flange,
remove circlip. Using puller, remove right axle flange.
6) Remove differential ring gear cover. If bearings are being
reused, mark differential adjuster ring (torque converter side)
bearing carrier to transaxle case. Using Bearing Adjuster Ring Socket
(3155), remove both differential bearing carriers. See Fig. 24. Remove
differential assembly from transaxle case. See Fig. 23.
7) Remove drive pinion and input transfer gear cover (if not
already removed). See Fig. 25. Using INCH-lb. torque wrench, measure
turning force of drive pinion and transfer gear bearings. Record
measurement for reassembly.
8) Engage parking pawl. Remove nut from pinion. See Fig. 26.
Using puller, remove output gear. See Fig. 27. Remove selector shaft
and parking pawl assembly. See Fig. 36. Remove outer bearing support.
Remove parking gear from pinion. Remove pinion and bearing from
transaxle. Using pin socket, remove inner bearing support with drive
pinion seal.
Fig. 22: Removing Input Transfer Gear Fastener Nut
Courtesy of Volkswagen United States, Inc.