Univex TRAX353 GPS Receiver User Manual


  Open as PDF
of 132
 
Page 52
How Do I Use It?
3. Tap tonishenteringtheaddress.
6. A list appears with the matching addresses. Tap the desired
one.
7. The map appears with the selected point in the middle. Tap
(Simple mode) or
(Advanced mode) from the Cursor menu. The route is then
automatically calculated, and you can start navigating.
Selecting an intersection as the destination
The procedure is explained starting from the Navigation menu.
1. Tap the following buttons:
(Simple mode), or
, (Advanced mode).
2. By default, TRAX353 proposes the country/state and settlement
where you are. If needed, tap the button with the name of the
country/state, and select a different one from the list.
3. If needed, change the settlement:
• Toselectthesettlementfromthelistofrecentlyusedones,
tap the
button.
• Toenteranewsettlement:
1. Tap the button with the name of the settlement, or if you
have changed the country/state, tap
.
2. Start entering the settlement name on the keyboard.
3. Get to the list of search results:
• Afterenteringacoupleofcharacters,thenamesthat
match the string appear in a list.
• Tap
to open the list of results before it
 previous next