Filter
Top Products
SPSx51 Modular GPS Receivers User Guide 69
Configuring the Receiver Using the Keypad and Display 6
Turning off AutoBase technology
You can turn off AutoBase technology using either the receiver’s keypad and display or
the web interface (see Receiver Configuration menu, page 90).
When AutoBase technology is off, you can establish a new base station position in the
receiver using the Edit Current or New Base (Here) menus. This does not automatically
generate a new application file, but changes the settings in the current application file.
When the receiver is turned on again, the most recent settings are always used.
To turn off AutoBase technology using the receiver:
1. In the Home screen, press
L .
2. Press
G . When the operation mode begins to flash, the receiver is in Edit mode
and you can change this setting.
3. Press
K to change to System Setup.
4. Press
L to accept the change.
5. Press
L again. You start to scroll through options in the System Setup menu.
6. Keep pressing
L until Autobase appears.
7. Press
G . The setting On flashes.
8. Press
K until it displays Off. Press L to accept the change.
9. Press
L again. The Active Appfile screen appears.
Note – If AutoBase is turned on, the AutoBase Warning screen appears.
To change the application file:
• Press G to display START Appfile.
• Press K to show SAVE Appfile.
• Press K to show DELETE Appfile.
• Press K to show START Appfile.