Filter
Top Products
97
6 F 8 A 0 9 3 4
* However, if a wrong password is entered when the mode is changed from the measuring mode to the
setting mode, appears and the password cannot be checked.
Switch operation
Display example
Description
The currently set password is displayed as
and the password cannot be checked.
●Changing the password
The following is an example to change the password from 123 to 453.
Switch operation
Display example
Description
Select "PASSWORD" from the setting item
selection menu.
The currently set password (123 in this
example) appears.
Then push .
The switches at the bottom change.
( are shown.)
At the same time, the cursor appears.
Push to move the cursor to the
digit you want to change and push
to change the number of the digit.
When you push , a message appears
to confirm whether the setting is OK or not.
If OK, push . If you want to redo the
setting, push .
Pushing cancels the setting operation
and exits the setting screen.
Note 1: If you set 000 for the password, it is considered as if the password is not used. In this case, the
password input confirmation screen does not appear when you move from the measurement
mode to the setting mode and all parameter setting items and restrictions on the parameter
setting items and calibration screen will be released.
Note 2: When you set your password, please be sure not to forget your password.
The password including how to check the password should be managed based on the
management standard of the system you use.