Filter
Top Products
64
6 F 8 A 0 9 3 4
Switch operation
Display example
Description
Pushing shows a message to confirm
whether the setting is OK or not.
If OK, push . If you need to redo the
setting, push .
Pushing cancels the setting operation
and exits the setting screen.
Note: The custom coefficient setting precision is 5 digits. Therefore, the input value changes
as follows depending on the setting value:
(Example) Input value, "85713038" → After the setting is confirmed, "85713040"
8.2.8 Custom Unit Setting
You can set the custom unit used when CUSTOM is selected for display setting.
For custom unit setting, you can set any combination of characters within 7 characters.
The following is an example to change the custom unit from AAA/BBB to XXX/ZZZ.
Switch operation
Display example
Description
Select "CS UNIT" from the setting item
selection menu.
The currently set custom unit (AAA/BBB in
this example) appears.
Then push .
* Pushing returns you to the setting
menu.
The switches at the bottom change.
( are shown.)
At the same time, the cursor appears.
Push or to change the
character.
When the desired character is obtained,
push . The cursor moves to the next
character.