Filter
Top Products
2-8 Raynav 300 GPS Plotter
Figure 2-6: Status Bar
➤ To change the scale rapidly, press and hold top or bottom of the RANGE
key.
The distance indicator at the left-hand side of the status bar is updated
whenever you change the display scale.
➤ To zoom in to a larger-scale (more detailed) display:
1. Use the trackpad to position the cursor in the area you wish to see in
larger scale.
2. Press the bottom of the
RANGE key to zoom into the area.
The display, centered on the cursor, is enlarged to show a larger scale
and the distance indicated in the status bar is updated.
➤ To zoom out to a smaller-scale (less detailed) display, press the top of the
RANGE key as many times as required, up to the maximum scale of
1200nm.
Customizing the Display Options
The SCREEN soft key enables the following screen display options to be
set on or off:
• Cursor Box (
CRSR BOX)
• Grid (
GRID)
• Personalized (
CUSTOM)
The factory default for these options is
ON.
Switching the Cursor Data Box On/off
The cursor data box provides the cursor’s position in latitude/longitude
and/or bearing/range.To see a full image, switch the data box off.
➤ To control the cursor data box:
1. Press the
SCREEN soft key.
2. Press the
CRSR BOX soft key to toggle the setting between ON and OFF.
To return to the default soft key display, press
CLEAR.
➤ To move the cursor box:
1. Use the trackpad to position the cursor over the box until the letters
BOX are displayed.
2. Press
ENTER to take control of the box, use the trackpad to move it to
the required position and press
ENTER again.
VES 43°27^05N
POS 001°02^83W
6nm
D4902-1
SOG 23.4kts
COG 234°M
81171_4.BOOK Page 8 Thursday, November 29, 2001 11:34 AM