Filter
Top Products
3-38 Raynav 300 GPS Plotter
When this option is selected, any waypoints received on SeaTalk or
NMEA are transferred and appended, one-by-one, to the Waypoint
List. Routes received on NMEA are appended to the Route List.You
can use this function to add waypoints from a PC connected via
NMEA.
• You can send the Waypoint and Route Lists from the display unit to
other instruments via NMEA using the
SEND WPT LIST function.
Sending the Waypoint List does not affect current routes. The
NMEA link could be to a PC.
Receiving Waypoints from Other Equipment
➤ To receive incoming waypoints on SeaTalk or NMEA:
1. Display the Waypoint List by pressing
MARK followed by the WAY-
POINT LIST
soft key.
Press the
WAYPOINT TRANSFER soft key.
2. Press the soft key
RECEIVE WPTS FROM ST/NMEA; the soft key
changes to
STOP RECEIVING WAYPOINTS.
When waypoints are transmitted by other equipment they are added
to the Waypoint List on the display unit. Routes transmitted on
NMEA are appended to the Route List.
3. To disable waypoint transfer, press the soft key
STOP RECEIVING WAY-
POINTS
.
Alternatively, press
CLEAR twice to close the Waypoint List.
Note: Where multiple waypoints have the same position, the last way-
point sent is the only one included in the Waypoint List.
Sending Waypoints to Other Equipment
➤ To send the Waypoint List on NMEA:
1. Display the Waypoint List as previously described, then press the
WAYPOINT TRANSFER soft key.
2. Press the
SEND WPT LIST ON NMEA soft key; the soft key changes to
STOP SENDING WAYPOINTS.
The Waypoint and Route Lists are transmitted from the display unit
to other equipment on NMEA.
3.7 Using Tracks
The Track function is used to mark, on-screen, the trail that your vessel
has followed, as though it had left a visible fixed wake.
81171_4.BOOK Page 38 Thursday, November 29, 2001 11:34 AM