Filter
Top Products
3-34 Raynav 300 GPS Plotter
3. To return to the default soft key display, move the cursor away from
the waypoint or press
CLEAR.
➤ To navigate directly to the cursor position:
1. Use the trackpad to position the cursor as required.
2. Press the
GOTO default soft key, followed by GOTO CURSOR.
If navigation is currently in progress you are warned
ALREADY FOL-
LOWING ROUTE. CANCEL ROUTE AND GOTO CURSOR?
i. To cancel the GOTO CURSOR operation, press NO.
ii. To continue with the
GOTO CURSOR operation (and stop the cur-
rent
GOTO ROUTE), press YES.
A temporary waypoint is placed as the target and navigation starts
towards it. The waypoint is shown as a square with a circle and dot at
its centre and is connected to the vessel’s starting position with a
dashed line.
The
STOP GOTO soft key is displayed.
Note: The temporary waypoint is not added to the Waypoint List. When
the
GOTO is complete or is stopped, the temporary waypoint remains on
the plotter screen until either another Goto or Follow is started or it is re-
moved.
3. To return to the default soft key display, move the cursor away from
the waypoint or press
CLEAR.
Follow a Route
Note: The current route may have been created on this display unit, or
created on another unit and received on this display via SeaTalk. If a
route has been reversed, or if a route on screen was being followed but
stopped before completion, the target waypoint, outlined by a square
box, may be different to that when the route was created. Always check
the target waypoint before initiating a Follow Route action.
➤ To follow the current route:
1. Press the
GOTO default soft key to display the Goto/Follow soft keys
(Figure 3-38).
or...
Place the cursor over a route leg until the letters
RTE and the route soft
keys (Figure 3-34) are displayed.
2. Press the
FOLLOW ROUTE soft key.
Your vessel’s current position becomes the origin and the target way-
point in the current route becomes the active target; the soft keys are
displayed as shown in Figure 3-39.
81171_4.BOOK Page 34 Thursday, November 29, 2001 11:34 AM