Filter
Top Products
Lubrication & Maintenance/500 Hour/12 Month
OURGP12,000004B –19–13OCT06–1/2
Replacing Fuel Filter Elements (Dual Filters)
X9811 –UN–23AUG88
High-Pressure Fluids
RG13543 –UN–21JUL04
Dual Fuel Filters (Final Filter at Left, Primary Filter with Bowl at
Right)
A—Retaining Ring
B—Filter Element
C—Drain Plug
D—Bleed Plug
CAUTION: Escaping fluid under pressure can
penetrate the skin causing serious injury.
Relieve pressure before disconnecting fuel or
other lines. Tighten all connections before
applying pressure. Keep hands and body away
from pinholes and nozzles which eject fluids
under high pressure. Use a piece of cardboard
or paper to search for leaks. Do not use your
hand.
If any fluid is injected into the skin, it must be
surgically removed within a few hours by a
doctor familiar with this type injury or gangrene
may result. Doctors unfamiliar with this type of
injury may call the Deere & Company Medical
Department in Moline, Illinois, or other
knowledgeable medical source.
1. Close fuel shut-off valve, if equipped.
2. Thoroughly clean fuel filter assemblies and surrounding
area.
NOTE: Perform the following steps on each fuel filter.
3. Loosen drain plug (C) and drain fuel into a suitable
container.
NOTE: Lifting up on retaining ring as it is rotated helps to
get it past raised locators.
4. Firmly grasp the retaining ring (A) and rotate it
clockwise 1/4 turn (when viewed from top). Remove
ring with filter element (B).
5. Inspect filter mounting base for cleanliness. Clean as
required.
6. On primary filter with water separator, remove filter
element from water separator bowl. Drain and clean
separator bowl. Dry with compressed air. Install water
separator bowl onto new element. Tighten securely.
35-5
110306
PN=85
Continued on next page