Filter
Top Products
107
MAINTENANCE
Cleaning and Storage
Storage Tips
Fluid Levels
Inspect the fluid levels. Add or change fluids as recommended in the
Periodic Maintenance Chart beginning on page 63.
S Demand drive unit (front gearcase)
S Rear g earcase (if equipped)
S Transmission
S Brake fluid (change every two years and any time the fluid looks
dark or contaminated)
S Coolant (test strength/fill)
Fog the Engine
1. Support the front end of the mac hine so the engine is leve l o r tilted
slightly re a rw ar d.
2. Remove the spa rk plug.
3. Pour 2- 3 tablespoons ( 29- 44 ml) of Premium 4 Synthetic 0W40
engine oil into t he hole.
NOTE: Use a section of small hos e and a small plas tic squeeze bottle
filled with the pre-measured amount of oil.
4. Reinstall the spark plug. Torque to specification.
5. Apply dielectric grease to the inside of the spark plug cap.
Reinstall the cap.
6. Turn the engine over several times using the recoil starter. Oil will
be forced in and around the piston rings and ring l ands, coating the
cylinder with a protective film of fresh oil.
7. Treat the fuel system with Polaris Carbon Clean. See page 106.
8. If Polaris fuel system additive is not used, the fuel tank, fuel lines,
and carburetor should be completely drained of gasoline.
9. To eliminate any fuel remaining in t he carburetor, run the engine
until it stops.