Polaris A07MH46AA Offroad Vehicle User Manual


 
2.21
MAINTENANCE
2
4. Loosen clamp and remove air filter assembly.
Cleaning:
5. Slip the pre-filter element off of main element. Clean the
pre filter with high flash point solvent, followed by hot
soapy water.
6. Rinse and dry thoroughly.
7. Inspect element for tears or damage.
8. Apply foam filter oil or clean engine oil and squeeze until
excess oil is removed.
9. Inspect main filter and replace if necessary. If the filter has
been soaked with fuel or oil it must be replaced.
Installation:
10. Reinstall pre-filter element over main filter. Be sure the
element covers entire surface of main filter without folds,
creases, or gaps.
11. Reinstall filter on main filter mount. Place filter clamp over
the assembly and tighten.
NOTE: Apply a small amount of general purpose grease
to the sealing edges of the filter before reinstalling.
NOTE: The air filter should rest on the filter support.
Proper placement of the air filter is important to prevent
rattles and air leaks. See Illustration above.
12. Install air box cover and secure with clips.
Air Box Sediment Tube
Periodically check the air box drain tube located toward the rear
of the machine. Drain whenever deposits are visible in the clear
tube.
1. Remove drain plug from end of sediment tube.
2. Drain tube.
3. Reinstall drain plug.
NOTE: The sediment tube will require more frequent
service if the vehicle is operated in wet conditions or at
high throttle openings for extended periods.
Gasket
Carb Boot
Main Element
Pre-Filter
Cover
Filter Clamp
Front
Main Filter
Filter Support
Air Box
Proper Filter Placement
Sediment Tube
Drain Plug