Filter
Top Products
10.39
ELECTRICAL
10
2. Pull the harness assembly out from the headlight assembly.
3. Remove the lamp and replace with a new head lamp.
NOTE: Do not touch the new lamp with bare fingers.
Hold the plastic part (1) of the lamp. Oil from your
skin leaves a residue, causing a hot spot that will
shorten the life of the lamp.
4. Install the harness assembly into the headlight assembly.
Turn the headlight harness clockwise to secure the head
lamp into place.
Lower Head Lamp Housing Removal (if required)
5. Remove the screw that secures the lower head lamp.
6. Pull the head lamp out of the locking tab.
Low Beam Headlight Adjustment
1. The low beam can be adjusted slightly upward or
downward.
2. Loosen the phillips screw located at the rear of the head
lamp.
3. Tilt the head lamp upward or downward.
4. Tighten the screw.
Headlamp Switch Test
1. Remove the headlight pod cover.
2. Set meter to DC Volts and probe the head lamp plug wires
(Brown and Yellow) at back of connector for 12 Volts.
3. Turn ignition and headlight on. If there is no power,
continue with checks to the harness and PDM.
Remove Screw
Loosen Screw
Brown
Yellow
Upper Headlamp Plug Wires
Brown
Green
Lower Headlamp Plug Wires