Filter
Top Products
User's manual NAVIGON 2100 | 2110
- 22 - Navigation
Impaired GPS reception
If GPS reception is impaired, navigation will be interrupted. The
navigation software remains active.
As soon as GPS reception is restored, the navigation system calculates
any change of position which has occurred in the meantime. Navigation
may simply be continued.
Arriving at your destination
When you have reached the specified destination, a message to this
effect will be displayed.
Only your current position (triangle in orange) will now be shown on the
map.
5.1 Starting NAVIGON 2100 | 2110
1. Switch your navigation device on.
If password protection has been activated, the P
ASSWORD LOCK
window opens.
2. Enter the password.
3. Tap the OK
button.
Each time the navigation device has been switched off completely
(by pressing the
(On/Off/Standby) switch for at least 6 seconds)
the following message appears when the software is started again:
"Please note that the road traffic regulations are prior to the
instructions of the navigation system. Please do not operate the
device while driving."
► After you have read and fully understood the text, tap the OK
button.
► If you do not accept these instructions, then tap the Cancel button
in order to quit the navigation software.
The M
AIN WINDOW will open. You can reach all of the navigation
software functions via the M
AIN WINDOW.
5.1.1 Initialising the GPS receiver
Note: It can take up to 20 minutes to initialise the integrated GPS
receiver for the first time.
Each time you switch on the receiver after this, the GPS reception will
start within one minute.
If the navigation device has been switched off for more than a week, the
next initialisation can take up to 10 minutes.