Navigon 2110 GPS Receiver User Manual


 
User's manual NAVIGON 2100 | 2110
Operating the navigation software - 17 -
Caution! Do not run cables directly next to safety-relevant devices and
power supplies.
Caution! After installation, check all safety-relevant equipment in the
car.
Caution! The car charger cable is to be connected to cigarette lighters
with an operating voltage of 12V only.
3 Operating the navigation software
3.1 Volume
The volume of the spoken driving instructions can be adjusted during
navigation.
You have started navigation. The map is open in Navigation or
Destination search mode.
1. Tap the
(Volume) button.
The volume bar opens. It contains three buttons for adjusting the
volume:
(Louder), (Quieter), (Volume on/off).
2. Tap the
(Volume) button again.
The volume bar closes.
3.2 Information
Symbols located at the top of the screen are used to display
information.
GPS
The GPS symbol can show the following GPS-reception status:
No GPS: The built-in GPS receiver is not operational. Contact customer
service if the problem persists.
No Signal: Data is being received from less than three satellites.
Position cannot be calculated.