Filter
Top Products
Replacing bulbs
568
Example illustration: S 550
1
Retaining screw
Removing
X
Turn retaining screw 1 counterclockwise.
X
Take washer fluid reservoir out of
mounting.
X
Place washer fluid reservoir to the side and
do not disconnect any wires or cables.
Installing
X
Guide washer fluid reservoir into mounting
so that the bottom retaining lug slides into
the rubber sleeve on the longitudinal
member.
X
Turn retaining screw 1 clockwise
High-beam flasher bulb
1
Bulb holder
2
Wire position
3
Grip
X
Turn housing cover 1 (Y page 567)
counterclockwise and remove it.
X
Turn bulb holder 1 counterclockwise until
it disengages
X
Take out bulb holder 1.
X
Take bulb out of holder 1.
X
Insert new bulb into bulb holder 1 and
press it all the way down.
X
Insert bulb holder 1 into guide in
headlamp.
The tab of the bulb holder 1 must be
positioned on the upper left-hand side and
wire 2 must point downward and to the
right (driver’s side headlamp) or downward
and to the left (passenger-side headlamp).
X
Turn bulb holder 1 clockwise until it
engages and grip 3 is in a horizontal
position.
X
Attach housing cover 1 (Y page 567) and
let it audibly engage to close.
Corner-illuminating lamp bulb
1
Bulb holder
2
Grip
3
Wire position
X
Turn housing cover 2 (Y page 567)
counterclockwise and remove it.
X
Turn bulb holder 1 counterclockwise until
it disengages.
Practical hints