Filter
Top Products
COMAND navigation (introduction)
108
1
Cross hair
2
Details of the cross hair position
3
Map scale
i
Display 2 may be the name of a road, for
example, provided the digital map contains
the necessary data.
If no data is available, display 2 shows:
R
the coordinates of the cross hair if the
geocoordinate display is switched on
(Y page 110) and the GPS signal is
strong enough
R
no display if the geocoordinate display is
switched off (Y page 110)
Adjusting the map scale
X
Rotate ymz.
Rotating clockwise zooms in, rotating
counterclockwise zooms out.
Saving cross hair position as destination
in last destinations list
X
Showing menu system, if necessary:
Press n.
X
Saving: Select Position £ Save
Position.
COMAND saves the cross hair position as
a destination in the last destinations list
(Y page 155).
Hiding the cross hair
X
Press back button L in the center
console (Y page 90).
The cross hair disappears and the map is
centered on the vehicle position.
or
X
Set the map to the vehicle or destination
position, see the explanation below.
Centering the map on the vehicle or
destination position
i
If you have moved the map, you can use
this function to rapidly return the map to
the position of the vehicle or destination. It
is only possible to center the map on the
destination position when route guidance
is active.
X
Centering on the vehicle’s position:
Select Navi £ Position £ Vehicle
Position Map.
or
X
Press back button L when the cross
hair is displayed.
X
Centering on the destination: Select
Navi £ Position £ Destination
Position Map.
Basic settings
i
You can make the following settings
regardless of whether route guidance is
active or inactive.
Map perspective
COMAND can display the map from a bird’s
eye view or in the normal map view.
Control systems