Filter
Top Products
Memory function
324
Storing positions into memory
X
Adjust the seats.
X
On the driver’s side, additionally adjust the
steering wheel and exterior rear view
mirrors to the desired positions.
X
Press memory button M.
X
Release memory button M and press
memory position button 1, 2 or 3 within
3 seconds.
When the settings are stored to the
selected position, an acknowledgement
signal sounds.
Recalling positions from memory
X
Press and hold desired memory position
button 1, 2 or 3 until the seat has
completely moved to the stored position.
On the driver’s side, also wait for the
steering wheel and exterior rear view
mirrors to move to the stored position.
i
Releasing the memory position button
stops movement to the stored positions
immediately.
The multicontour seat and/or lumbar
support will continue to be adjusted.
Storing exterior rear view mirror
parking position
For easier parking, you can adjust the
passenger-side exterior rear view mirror so
that you can see the right rear wheel as soon
as you engage reverse gear R.
For information on activating the parking
position, see (Y page 322).
1
Memory button M
2
Adjustment button
3
Passenger side exterior rear view mirror
button
4
Driver’s side exterior rear view mirror
button
X
Stop the vehicle.
X
Switch on the ignition.
X
Press button 3.
The passenger-side exterior rear view
mirror is selected.
X
Adjust the passenger-side exterior rear
view mirror with adjustment button 2 so
that you see the rear wheel and the road
curb.
X
Press memory button M 1.
X
Within 3 seconds, press bottom of
adjustment button 2.
The parking position is stored if the mirror
does not move.
i
If the mirror does move, repeat the above
steps. After the setting is stored, you can
move the mirror again.
Controls in detail