Mercedes-Benz 2009 S63 AMG Automobile User Manual


 
Starter switch positions
307
X
Canceling: Insert the mechanical key in
the trunk lid lock.
X
Turn the mechanical key counterclockwise
to neutral position $ and remove the
mechanical key in that position to unlock
the trunk.
You can now open the trunk.
Power closing assist for doors and
trunk lid
It is not necessary to slam the door or trunk
lid closed. An electrical power-assisted
mechanism draws doors and trunk lid closed
quietly and automatically once door and trunk
lid has been latched. When the electrical
power-assisted mechanism has stopped,
doors and/or trunk can be reopend.
G
Warning!
To prevent possible personal injury, always
keep hands and fingers away from the door
or trunk opening when closing a door or the
trunk lid. Be especially careful when small
children are around.
In case of danger, pull the inside or outside
door handle, or pull the trunk lid handle.
To prevent personal injury, never actuate
the closing assist mechanism by tampering
with the door or trunk lid latch.
G
Warning!
Only drive with the doors closed.
Otherwise, one or more of the doors could
open while the vehicle is in motion, putting
you and/or others at risk.
G
Warning!
Make sure the trunk is closed when the
engine is running and while driving. Among
other dangers, deadly carbon monoxide
(CO) gases may enter vehicle interior
resulting in unconsciousness and death.
X
Power closing assist for doors: Press the
doors gently past the initial engage position
into the lock.
X
Power closing assist for trunk lid: Press
the trunk lid gently into its lock.
Starter switch positions
SmartKey
G
Observe Safety notes, see
page 62.
Starter switch
}
For removing SmartKey
$
Power supply for some electrical
consumers, e.g. radio
%
Ignition (power supply for all electrical
consumers) and driving position
&
Starting position
When you switch on the ignition, all lamps
(except high-beam headlamp indicator lamp,
and turn signal indicator lamps unless
activated) in the instrument cluster come on.
If a lamp in the instrument cluster fails to
come on when the ignition is switched on,
Controls in detail
Z