Filter
Top Products
Panorama roof with power tilt/sliding panel
413
G
Warning!
Pulling and holding the roof panel switch to
close the tilt/sliding panel immediately
after it had been blocked two times will
cause the tilt/sliding panel to close without
any reversal function for as long as you hold
the roof panel switch.
Synchronizing
The tilt/sliding panel and front roller
sunblinds must be synchronized after a
malfunction or if the tilt/sliding panel does
not open smoothly.
!
Do not attempt to open the tilt/sliding
panel before the tilt/sliding panel is
properly synchronized. The tilt/sliding
panel could otherwise lock-up in the open
position.
If the tilt/sliding panel cannot be closed or
synchronized, contact an authorized
Mercedes-Benz Center or call Roadside
Assistance.
Tilt/sliding panel and front roller
sunblind
X
Switch on the ignition.
X
Pull and hold the roof panel switch several
times in direction of arrow 3
(Y page 409) until the tilt/sliding panel is
fully closed.
X
Keep holding the roof panel switch in
direction of arrow 3 for approximately
1 second.
X
Pull and hold the roof panel switch several
times in direction of arrow 3 until the front
roller sunblind is fully extended.
X
Keep holding the roof panel switch in
direction of arrow 3 for approximately
1 second.
X
Check the express operation feature of the
front roller sunblind.
If the front roller sunblind retracts
completely, the front roller sunblind is
synchronized. Otherwise repeat the above
steps.
X
Check the express operation feature of the
tilt/sliding panel (Y page 411).
If the tilt/sliding panel opens completely,
the tilt/sliding panel is synchronized.
Otherwise repeat the above steps.
Rear roller sunblind
X
Switch on the ignition.
X
Pull switch 1 (Y page 410) in the rear door
control panel several times until the rear
roller sunblind is fully extended.
X
Keep holding switch 1 for approximately
1 second.
X
Check the express operation feature of the
front roller sunblind.
If the rear roller sunblind retracts
completely, the rear roller sunblind is
synchronized. Otherwise repeat the above
steps.
Controls in detail
Z