Filter
Top Products
Power windows
126
X
Express operation: Press or pull switch
1 to 4 past the resistance point and
release.
The corresponding window opens or closes
completely.
X
Stopping during express operation:
Press or pull the respective switch again.
Closing when a door window is blocked
G
Warning!
Make sure that nobody can become
trapped and be seriously or even fatally
injured when closing a door window with
greater force or without automatic reversal
function.
If the upward movement of a door window is
blocked during the closing procedure, the
door window will stop and open slightly.
However, the door window will exert greater
force before reversing than when the door
window is closed in express operation. Please
exercise caution!
X
Immediately after the door window has
stopped because it was blocked, pull the
respective switch upwards until the door
window is fully closed.
If the door window is blocked again and opens
slightly:
X
Immediately after the door window was
blocked, pull the respective switch
upwards until the door window is fully
closed.
G
Warning!
Pressing and holding the switch to close the
door window immediately after it had been
blocked two times will cause the door
window to close without any reversal
function for as long as you hold the switch.
Hinged quarter windows
X
Switch on the ignition.
X
Opening: Press switch 5 and release.
Both hinged quarter windows open
completely.
X
Closing: Pull switch 5 and release.
Both hinged quarter windows close
completely.
i
When the obstruction sensor detects that
a hinged quarter windows is blocked during
the closing process, they will stop and open
slightly.
X
Halting closing process: Press or pull
switch 5 once more during the closing
process.
The hinged quarter windows will stop and
open completely.
i
For your safety, the hinged quarter
windows cannot be opened again until
4 seconds have passed.
Synchronizing door windows
The door windows must be synchronized after
the battery has been disconnected or if the
door windows cannot be fully closed (express
operation).
Each door window must be synchronized
separately.
X
Close all doors.
X
Switch on the ignition.
X
Pull and hold switch 1, 2, 3 or 4
(Y page 125) until the respective door
window is closed.
The door window opens again slightly.
Controls in detail