Filter
Top Products
Power windows
125
door window encounters an obstruction
that blocks its path, the automatic reversal
function will stop the door window and
open it slightly.
The door windows operate differently when
the switch is pressed and held. See the
“Closing when a door window is blocked”
section in this chapter for details.
The closing of a door window can be
immediately halted by releasing the switch
or, if the switch was pulled past the
resistance point and released, by either
pressing or pulling the respective switch.
The closing of the hinged quarter windows
can be immediately halted by pressing or
pulling the switch.
If a window encounters an obstruction that
blocks its path in a circumstance where you
are closing the windows by pressing and
holding button j on the SmartKey or by
pressing and holding the lock button
(vehicles with KEYLESS-GO) on an outside
door handle, the automatic reversal
function will not operate.
Activate the override switch when children
are riding in the back seats of the vehicle.
The children may otherwise injure
themselves, e.g. by becoming trapped in
the window opening.
G
Observe Safety notes, see
page 68.
G
Warning!
Do not keep any part of your body up
against the window pane when opening a
window. The downward motion of the pane
may pull that part of your body down
between the window pane and the door
frame and trap it there. If there is a risk of
entrapment, release the switch and pull it
to close the window.
i
You can also open or close the windows
using the SmartKey, see “Summer opening
feature” (Y page 127) and “Convenience
closing feature” (Y page 127).
i
After switching off the ignition or
removing the SmartKey from the starter
switch, you can operate the windows until
you open the driver’s or front passenger
door. If no door was opened you can
operate the windows for up to 5 minutes.
1
Left front door window
2
Right front door window
3
Right rear door window
4
Left rear door window
5
Hinged quarter windows
Door windows
X
Switch on the ignition.
X
Opening/Closing: Press or pull and hold
switch 1 to 4 to the resistance point.
The corresponding window will move
downwards or upwards until you release
the switch.
Controls in detail
Z