Filter
Top Products
57
Getting started
Driving
The combination switch resets automati-
cally after major steering wheel move-
ments.
Windshield wipers
The combination switch is located on the
left of the steering column.
Combination switch
1 Switching on windshield wipers
2 Single wipe
Wiping with windshield washer fluid
̈ Switch on the ignition (୴ page 37).
i
To signal minor directional changes such as
changing lanes, press combination switch only
to point of resistance and release. The corre-
sponding turn signals will flash three times.
!
Do not operate the windshield wipers when
the windshield is dry. Dust that accumulates on
a windshield might scratch the glass and/or
damage the wiper blades when wiping occurs on
a dry windshield. If it is necessary to operate the
windshield wipers in dry weather conditions, al-
ways operate the windshield wipers with wind-
shield washer fluid (
୴ page 59).
!
If anything blocks the windshield wipers
(leaves, snow, etc.), switch them off immediate-
ly.
ț For safety reasons, stop the vehicle in a safe
location and
ț remove SmartKey from starter switch
or
ț turn off the engine by pressing the
KEYLESS-GO* start/stop button and
open the driver’s door (with the driver’s
door open, starter switch is in
position 0, same as with SmartKey re-
moved from starter switch)
before attempting to remove any blockage.
ț Remove blockage.
ț Turn the windshield wipers on again. ୴୴