Filter
Top Products
327
Operation
Engine compartment
1 Oil dipstick
2 Upper (max) mark
3 Lower (min) mark
To check the engine oil level with the oil
dipstick, do the following:
̈ Open the hood (୴ page 324).
̈ Pull out oil dipstick 1.
̈ Wipe oil dipstick 1 clean.
̈ Fully insert oil dipstick 1 into the
dipstick guide tube.
̈ Pull out oil dipstick 1 again after
approximately 3 seconds to obtain ac-
curate reading.
The oil level is correct when it is be-
tween the lower (min) mark 3 and
upper (max) mark 2 of oil dipstick 1.
̈ If necessary, add engine oil.
For adding engine oil, see “Adding engine
oil”.
For more information on engine oil, see
“Fuels, coolants, lubricants etc.”
(
୴ page 486).
For more information on messages in the
multifunction display concerning engine
oil, see the “Practical hints” section
(
୴ page 416).
Adding engine oil
i
All models (except E 63 AMG):
The filling quantity between the upper and lower
marks on the oil dipstick is approximately
2.1 US qt. (2.0 l).
E63AMG:
The filling quantity between the upper and lower
marks on the oil dipstick is approximately
1.6 US qt. (1.5 l).
!
Only use approved engine oils and oil filters
required for vehicles with Maintenance System
(U.S. vehicles) or FSS PLUS (Canada vehicles).
For a listing of approved engine oils and oil fil-
ters, refer to the Factory Approved Service Prod-
ucts pamphlet (USA only) in your vehicle
literature portfolio, or contact an authorized
Mercedes-Benz Center.
Using engine oils and oil filters of specification
other than those expressly required for the Main-
tenance System (U.S. vehicles) or FSS PLUS
(Canada vehicles), or changing of oil and oil filter
at change intervals longer than those called for
by the Maintenance System (U.S. vehicles) or
FSS PLUS (Canada vehicles) will result in engine
or emission control system damage not covered
by the Mercedes-Benz Limited Warranty.