Filter
Top Products
467
Practical hints
Jump starting
The jump-start contacts are located in the
engine compartment.
̈ Make sure the two vehicles do not
touch.
̈ Turn off all electrical consumers.
̈ Apply the parking brake (୴ page 62).
̈ Make sure the gear selector lever is set
to position P.
̈ Open the hood (୴ page 324).
1 Negative (-) terminal
2 Cover of positive (+) terminal
̈ Open cover of the positive terminal.
̈ Connect positive terminal 2 and the
positive terminal of the charged battery
with the jumper cable. Clamp cable to
charged battery first.
̈ Start engine of the vehicle with the
charged battery and run at idle speed.
̈ Connect negative terminal 1 and the
negative terminal of the charged
battery with the second jumper cable.
Clamp cable to charged battery first.
̈ Start the engine of the disabled
vehicle.
You can now turn on the electrical con-
sumers. Do not switch on the headlamps
under any circumstances.
̈ Remove the jumper cables first from
negative terminals on each battery and
then from the positive terminals on
each battery.
You can now switch on the headlamps.
̈ Have the battery checked at the near-
est authorized Mercedes-Benz Center.
Warning! G
Keep flames or sparks away from battery.
Do not smoke.
Observe all safety instructions and precau-
tions when handling automotive batteries
(
୴ page 330).
!
Never invert the terminal connections!