Filter
Top Products
240
Controls in detail
Power windows
̈ Switch on the ignition (୴ page 37).
Opening the windows
̈ Press switch 1 to 4 to the resistance
point.
The corresponding window will move
downwards until you release the
switch.
Closing the windows
̈ Pull switch 1 to 4 to the resistance
point.
The corresponding window will move
upwards until you release the switch.
Fully opening the windows
(Express-open)
̈ Press switch 1 to 4 past the resis-
tance point and release.
The corresponding window opens com-
pletely.
Fully closing the windows
(Express-close)
̈ Pull switch 1 to 4 past the resis-
tance point and release.
The corresponding window closes com-
pletely.
If the upward movement of the window is
blocked during the closing procedure, the
window will stop and open slightly.
i
Operating the windows from the rear is not
possible if you activate the override switch
(
୴ page 95).
i
With the SmartKey in starter switch
position 0 or removed from the starter switch,
the windows can be operated:
ț until you open the driver’s or front passen-
ger’s door
ț for at least 5 minutes
Warning! G
If you pull and hold the switch up when clos-
ing the window, and upward movement of
the window is blocked by some obstruction
including but not limited to arms, hands, fin-
gers, etc., the automatic reversal will not op-
erate.
Warning! G
Driver’s door only:
If within 5 seconds switch is again pulled
past the resistance point and released, the
automatic reversal will not operate.