Filter
Top Products
19
LOG SONAR CHART DATA
If you have a MMC installed in the
unit, the sonar data shown on the
screen can be saved to the MMC.
This can be played back at any
time.
To save the chart data, press the
MENU key, then select “Log So-
nar Chart Data”. The screen at
right appears.
To save data using the defaults on this screen, highlight “Start Logging”
and press the ENT key. You can change any of the defaults on this screen,
if desired. When finished, press the EXIT key.
DISPLAY SETTINGS
Contrast/Backlight/Display Mode
To adjust these settings, press
the MENU key
twice
. This shows
the second menu page. Highlight
“Screen” at the top of the page
and press the ENT key. The
screen at right appears.
Contrast is highlighted on this
menu by default. To adjust it,
press the ENT key and use the
left or right arrow keys to change
it. Press the ENT key when fin-
ished.
To adjust the backlighting’s brightness, first turn it on by pressing the PWR
key. Next, highlight the “Backlight” label, then use the arrow keys to adjust
it. Press the ENT key when you’re finished.
Display Mode optimzes the LCD (liquid crystal display) for specific view-
ing conditions. Normally, it should stay in the default mode. However, the
High Contrast mode may be useful for shaded light conditions and the
Night Viewing mode for use at night. Select the “Display Mode” menu,
press the ENT key, then select the desired setting from the drop-down
menu. Press the ENT key when you’re finished.