Filter
Top Products
78GPS1200
Reference Station
Configure a NET
port step-by-step
In order to use a NET port for the remote interface connection, the RJ45 connector
of the GRX1200 Pro/GRX1200 GG Pro must be connected to a network hub or
router. If connecting directly to a PC, a crossed Ethernet cable is required. A static
IP address must be available. Talk to the network administrator in order to obtain a
static network IP address. The following step-by-step description shows how to
create a NET port and assign the remote interface to it. Refer to the GPS1200 Tech-
nical Reference Manual and to the "GRX1200 Series - Getting Started" for more
information.
Step Description
1. Main Menu: Config...\Instrument Settings...\Set NET Parameters
2. CONFIGURE Set NET Parameters
Enter the Internet Protocol address, the network mask and the gateway.
3. CONT (F1) returns to GPS1200 Main Menu.
4. Main Menu: Config...\Interfaces...
5. CONFIGURE Interfaces
Highlight Remote.
6. EDIT (F3) to access CONFIGURE Interfaces.
7. Highlight a NET port.